STL models Banbaro horns for alpha F (Monster Hunter: World)

$5.00

3D print models (STL files) horns, styled after the Banbaro female Alpha armor set from Monster Hunter: World Iceborne.

The STL files are ready to print, and are already oriented for an optimal 3d print result. Use sufficient support and brim so the angled print is successful.

IMPORTANT: licensed Creative Commons – Non Commercial/ No Derivatives (nc/nd)
You are not licensed to sell raw 3dprint kits made using this STL.

In stock

Description

3D print models (STL files) horns, styled after the Banbaro female Alpha armor set from Monster Hunter: World Iceborne.

The STL files are ready to print, and are already oriented for an optimal 3d print result. Use sufficient support and brim so the angled print is successful.

Printing instructions:
The horns can be nicely printed using 3 walls and 0% infill. Use 60% support at 12% density in zigzag or grid pattern.
Or: included is a mesh file that you can use as support mesh: configure your supports first, then turn supports off, and then import the support block on the right place. Set the support block to print as ‘support’ and then slice your gcode.

Finishing instructions:
The horns have sockets for the included pegs, suitable for 12×3 magnets. The pegs can be sewn or screwn to your wig or headband.
Sand your 3D prints using 100-150 grit sandpaper, with royal use of primer or filler spray inbetween to get a smooth surface. When you’re satisfied with the results, your last layer should be a primer spray, before painting it with acrylics. Protect your paintjob with a varnish spray in satin or gloss.

 

The 3d models are made by me. Because Etsy does not allow stl file extensions, the file is packed in a zip file. This can be unpacked by most operating systems without the need of additional applications into your useable STL files. If you do not unpack them, the models will not work!

Instagram