STL model Valeera daggers (World of Warcraft)

Description

STL 3d models for 3dprinting your own Valeera daggers, based on the details seen in World of Warcraft: Midnight.
Suitable for LED lights if desired. (read the print instructions for this in the download)
Total length of 75cm (about 30 inches).
Part STL files are already scaled and orientated in the best print quality orientation.
Parts are scaled based on a 3dprinter with at least 250x250x250mm build volume at 100% scale.
Recommended filament: PETG.

Recommended post-processing:
Use the offset slots to align and glue the parts together.
You can use superglue (with accelerant), epoxy glue or any other strong glue you like to fasten parts together.

Sand your 3D prints using 100-150 grit sandpaper, with royal use of primer or filler spray in-between to get a smooth surface. When you’re satisfied with the results, your last layer should be a primer spray, before painting it with acrylics, spraypaints etc. Protect your paint with a varnish spray in satin or gloss.

Finished photo was made with a one-piece hollow blade print with usb lights inside. If your printer is less than 500mm in height, you will have to print the blade in two pieces (included).

The 3d models are made by me. These files are packed in a ZIP folder, you need to extract the files correctly to be able to use them, if you have problems doing so, please contact me.
Non/commercial license information: You may not resell or distribute these files in any way. You may not sell 3D prints (such as raw 3d kits) made using these files, with the exception of custom (one-time) commission requests.

Disclaimer: Any rights are reserved for the copyright holders. This is a fanmade item, I am not in any way an official reseller or licensed by the relevant IP owners.