$6.00
STL 3d models for 3dprinting your own Hornet needle, based on the details seen in Silksong.
This needle has an oval shape, there is no diamond crease in the center.
Total length of 150cm (about 5ft).
Part STL files are already scaled and orientated in the best print quality orientation.
Parts are scaled based on a 3dprinter with at least 250x250x250 mm build volume at 100% scale.
Recommended filament: PETG.
You can also get the needle printed in two pieces (blade and handle plus pvc pipe) for you in PETG filament. Please email for this!
Description
STL 3d models for 3dprinting your own Hornet needle, based on the details seen in Silksong.
This needle has an oval shape, there is no diamond crease in the center. The needle slightly tapers in a curve to the point end.
Total length of 150cm (about 5ft).
Part STL files are already scaled and orientated in the best print quality orientation.
Parts are scaled based on a 3dprinter with at least 250x250x250 mm build volume at 100% scale.
Recommended filament: PETG.
You can also get the needle printed in two pieces (blade and handle plus pvc pipe) for you in PETG filament. Please email for this!
Recommended post-processing:
You need approx 100cm pvc pipe with an outer diameter of 27mm. (the 3/4 inch PR 200 charlotte pipe from home depot fits). 3/4 in this context refers to the class of pipe and doesnt match any of the nominal dimensions for the charlotte pipe PR200, so doublecheck your nominal dimensions to make sure it fits.
Use the offset slots to align and glue the parts together.
You can use superglue (with accelerant), epoxy glue or any other strong glue you like to fasten parts together.
Sand your 3D prints using 100-150 grit sandpaper, with royal use of primer or filler spray in-between to get a smooth surface. When you’re satisfied with the results, your last layer should be a primer spray, before painting it with acrylics, spraypaints etc. Protect your paint with a varnish spray in satin or gloss.
Finished photo was made with a one-piece needle print.
The 3d models are made by me. These files are packed in a ZIP folder, you need to extract the files correctly to be able to use them, if you have problems doing so, please contact me.
Non/commercial license information: You may not resell or distribute these files in any way. You may not sell 3D prints (such as raw 3d kits) made using these files, with the exception of custom (one-time) commission requests.
Disclaimer: Any rights are reserved for the copyright holders. This is a fanmade item, I am not in any way an official reseller or licensed by the relevant IP owners.
