$10.00
STL 3d models for the mask of Cerberus from Fortnite (shoulder head is also included). Jaw is hinged and will move when you move your own mouth when assembled. Separate pieces for the ears, upper teeth, mask, tongue and jaw. Each piece slots to fit, but glue is required to permanently assemble the mask. Hinges, hooks (for rubber bands) and clips (for elastic head band) included in the model.
You will need 2 rubber bands (office supplies is fine) and a ~25mm elastic band about 30cm long to finish and wear the mask.
Commercial use not allowed. Please read more details below.
Description
STL 3d models for the mask of Cerberus from Fortnite. Jaw is hinged and will move when you move your own mouth when assembled. Separate pieces for the ears, upper teeth, mask, tongue and jaw. Each piece slots to fit, but glue is required to permanently assemble the mask. Hinges, hooks (for rubber bands) and clips (for elastic head band) included in the model.
Recommended print settings:
This model is suitable for a print volume of atleast 220mm in width and 220mm in height (100%) scale to be able to print it in one piece. Extra parts are included for smaller-sized printers.
The filament weight estimate is 500 to 600 grams.
If your head circumference is 23 inches or greater, it is recommended to print 105% scale.
The STL files are ready to print, and are already oriented for an optimal 3d print result. I recommend minimum 3 wall layers and 10% infill for this 3dmodel.
You need supports for the teeth, and possibly for a bit of jaw and ear overhang. You can ignore the overhang on the mask as it’ll be on the inside anyway.
You will need to print the ear and teeth twice, mirror these pieces to get the left side (this option is available in all 3dprint slicer apps).
Recommended post-processing:
The pieces can be glued together with superglue, I recommend using an accelerant spray to ensure a strong and quick connection.
You can also use epoxy or any other strong glue you like.
You will need 2 rubber bands (office supplies is fine) and a ~25mm elastic band about 30cm long to finish and wear the mask.
If you want to add some type of eyes, the curvature of the eye suits a 80mm diameter transparent ball (youll have to cut out a section of the ball or its too big, i use a dremel).
Painting instructions:
Sand your 3D prints using 100-150 grit sandpaper, with royal use of primer or filler spray inbetween to get a smooth surface. When you’re satisfied with the results, your last layer should be a primer spray, before painting it with acrylics. Protect your paintjob from scratches with a varnish spray or brush coat in matte, satin or gloss.
The 3d models are made by me. These files are packed in a ZIP file, you need to extract the files correctly to be able to use them, if you have problems doing so, please contact me.
You may not resell or distribute these files in any way. You may not sell 3D prints made using these files, with the exception of private (one-time) commissions.
Disclaimer: Any rights are reserved for Epic Games. This is a fanmade item, I am not in any way an official reseller or licensed by the relevant IP owners.
